MK117 Electronic Control Pad for steam showers.
Designed to fit cut out in central shower tower panel: 148mm x 85mm
This item comes with pre-fitted cable to connect to the steam generator unit via a pinned plug data connection.
Fitting of this item is as simple as removing the 4 fixingbolts holding the pad in place and pushing the pad into the shower cabin fromthe rear of the shower. Clean the area of any silicone used to provide waterprotection, apply a new bead of sealant to bed the pad into, place the pad inposition, re-fasten the bolts and connect the data lead. Clean up any excesssealant and power the system back up.
UPGRADING YOUR CONTROL PAD
When replacing control pads you MUST replace with the same pad as the connectionsfrom the pad can be different to those on the steam generator or electronics.Additionally the data communication to and from the generator must correspond (think of it like pointing a television remote at a different Make/Model of television, the remote would not control the television correctly)
Click a manual name below to open the file in a new tab/window:
MK117control panel manual.pdf